ISemaphore
ISemaphore is a member of CP Subsystem API.
For detailed information, see the CP Subsystem chapter.
|
Hazelcast ISemaphore is the distributed implementation of java.util.concurrent.Semaphore.
Controlling Thread Counts with Permits
Semaphores offer permits to control the thread counts when performing concurrent activities. To execute a concurrent activity, a thread grants a permit or waits until a permit becomes available. When the execution is completed, the permit is released.
ISemaphore with a single permit may be considered as a lock. Unlike the locks,
when semaphores are used, any thread can release the permit depending on the configuration,
and semaphores can have multiple permits. For more information, see the Semaphore Configuration section.
|
| Hazelcast ISemaphore does not support fairness at all times. There are some edge cases where the fairness is not honored, e.g., when the permit becomes available at the time when an internal timeout occurs. |
When a permit is acquired on ISemaphore:
-
If there are permits, the number of permits in the semaphore is decreased by one and the calling thread performs its activity. If there is contention, the longest waiting thread acquires the permit before all other threads.
-
If no permits are available, the calling thread blocks until a permit becomes available. When a timeout happens during this block, the thread is interrupted.
Example Semaphore Code
The following example code uses an IAtomicLong resource 1000 times,
increments the resource when a thread starts to use it and decrements
it when the thread completes.
HazelcastInstance hazelcastInstance = Hazelcast.newHazelcastInstance();
ISemaphore semaphore = hazelcastInstance.getCPSubsystem().getSemaphore( "semaphore" );
IAtomicLong resource = hazelcastInstance.getCPSubsystem().getAtomicLong( "resource" );
semaphore.init(4);
for ( int k = 0 ; k < 1000 ; k++ ) {
System.out.println( "At iteration: " + k + ", Active Threads: " + resource.get() );
semaphore.acquire();
try {
resource.incrementAndGet();
Thread.sleep( 1000 );
resource.decrementAndGet();
} finally {
semaphore.release();
}
}
System.out.println("Finished");If you execute the above code 5 times, the following output appears:
At iteration: 0, Active Threads: 1
At iteration: 1, Active Threads: 2
At iteration: 2, Active Threads: 3
At iteration: 3, Active Threads: 3
At iteration: 4, Active Threads: 3
As you can see, the maximum count of concurrent threads is equal or smaller than three. If you remove the semaphore acquire/release statements in the above example, you will see that there is no limitation on the number of concurrent usages.
